ENTERPRISE COMMUNICATOR

comm510

Sr Member
RPF PREMIUM MEMBER
I've had this project done and on the bench for a year and a half now. Too much other stuff in the way but I have had a request for a finished piece so I thought I'd show it off. Castings are not AA.

FSentCmprts001.jpg


Electronics chirp when the lid is released, then the signal lights come on.... then go down and up again in a random pattern as if you were searching for a signal. The battery graphic actually is a battery meter. 2 on is full power, 1 on is half and 1 blinking means replacement is neccesary. It's a sweet little thing.


Enjoy. :)
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top