Dye sub printing on Smooth-On plastic?

Thread starter druzyek
Start date Nov 3, 2020

druzyek

New Member

Nov 3, 2020

Is there a way to print a picture or even single color design on casted plastic similar to Smooth-On? Apparently, the dye sub process activates around 400 F whereas the deformation temperature listed for most of the Smooth-On plastics is less than 150 F. I'm hoping for something fairly robust that will never smudge even after a lot of handling.

This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.