DH-17 (ANH Rebel Blaster) Scope Rings Help

[Captain Dunsel]

I am getting started on a ANH DH-17 build using a Jedi Father pistol cast and a Warhammer Single Point Scope replica. I’ll be adding greeblies as I pick them up from there.

I should know this (please, don’t make me hand in my RPF membership card), but what are the proper scope rings for this build?

Thanks!

 

[Captain Dunsel]

Following-up.

I know that these are Weaver rings but am looking for more specific info regarding the ring models, etc.

Any help is greatly appreciated!

 

[OdiWan72]

No info / part number or anything on these that I know of

 

[Captain Dunsel]

No info / part number or anything on these that I know of

OK. Other than them being the football type and having the large screw knobs, do you know if these are high-profile rings or low-profile?

 

[mugatu]

Those would be low or mid profile rings.
Are these not the rare Single-Point rings?

 

[thd9791]

What are the rare single point rings?

I've always thought they were low, football shaped, with the ridged rings.

The scope mounts are custom, aluminum stock 90 degree or some C profile with a rectangular notch taken out of the center for the weaver screw/bar on the rings.

 

[Captain Dunsel]

Hmmmm....this could be more difficult than I thought if the scope mount was custom machined.