CWs Arrow--Grapple/Jettison Arrow

NuadaDesigns

Sr Member
RPF PREMIUM MEMBER
First test prints for the head of the jettison/grapple arrow. A good few changes to make yet.
More tomorrow.
IMG_20201215_205247_362.jpg
IMG_20201228_192509.jpg
IMG_20201228_192740.jpg
IMG_20201228_192748.jpg
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top