Curious about using multiple Smooth On products on one piece.

Thread starter Dragonmaster525
Start date Jun 8, 2015

Dragonmaster525

New Member

Jun 8, 2015

I've been using Smooth on Epsilon and 65d for a little bit now, and I just got curious if anyone has used a coat of epsilon, followed by a coat of 65d for rigidity.

I like how Epsilon covers up lines, but I'd prefer my foam pieces to be a bit more rigid once built.

This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.