Cheap Fiber optics option
- Thread starter GF
- Start date
vaderdarth
Master Member
GF, I agree, I'd bundle several and make them roughly 1mm. The effect will be quite similar.
Dave
Dave
nutsnbolts
New Member
GF, I agree, I'd bundle several and make them roughly 1mm. The effect will be quite similar.
Dave
Just remember that those cheapy fibers are often quite brittle and you can easily snap 'em into pieces during an install.
137th Gebirg
Well-Known Member
Well, you could always use vinyl or nylon fishing line. It's clear but "dirty". You'll have reduction in light transmission quicker than the "good stuff", but if you're not making them too long, it should work just fine. There should also be a greater variety of thickness to choose from and no breakage like nutsnbolts mentioned about real fiber. And, of course, it's super-cheap.
Worked for me anyway, back in the day before fiber was easily available commercially.
Worked for me anyway, back in the day before fiber was easily available commercially.
Last edited:
Apophis
Sr Member
Hello all,
I had the same idea some time ago about using the bundle lights from a couple $1 stores I had spotted! Lots of strands at a cheaper price.
I found them to be very thin and brittle! There was no consistency between the strands. And the super-glue tended to melt the strands off so I had to pitch the idea as unworkable! Turned out not to be worth the money I spent.
If someone found a usable way to use these cheaper quality strands I would like to know.
Until then I will stick to the good stuff, less frustrating that way!
Later all, Petseal
I had the same idea some time ago about using the bundle lights from a couple $1 stores I had spotted! Lots of strands at a cheaper price.
I found them to be very thin and brittle! There was no consistency between the strands. And the super-glue tended to melt the strands off so I had to pitch the idea as unworkable! Turned out not to be worth the money I spent.
If someone found a usable way to use these cheaper quality strands I would like to know.
Until then I will stick to the good stuff, less frustrating that way!
Later all, Petseal
Gigatron
Sr Member
You had to be using something other than super glue.
Cyanoacrylate (the main chemical component of all super glues) is not "hot". It's not a chemical adhesive like styrene glue or other polymers. It's a mechanical adhesive which is why it works best on porous materials. It doesn't produce heat during a chemical cure and it doesn't react with the materials being bonded. It only reacts with water. It'll react with the water in your skin (gluing your fingers together) and reacts with water vapor in the air. It takes much longer for it to dry in air that has low humidity.
Styrene/pvc/etc. glues actually melt the plastics so that when it cures, the two pieces actually become one solid piece. You can't pull the pieces apart because they are no longer 2 pieces.
Mechanical adhesives, like krazy glue, have great pull strength (the guy hanging from his hard hat), but little, to no, shear strength; a little tap on the side will knock the two pieces apart. You can also break a CA bond by putting it in the freezer. Since CA reacts and cures with water, all you have to do is freeze the trapped water molecules, causing them to expand and making the bond brittle.
-Fred
