J JavaJedi New Member Jun 8, 2015 #1 I want to connect the end piece to the butt of the lightsaber but they are the same size. Not sure if there is a cheap way of making it happen. Any ideas?
I want to connect the end piece to the butt of the lightsaber but they are the same size. Not sure if there is a cheap way of making it happen. Any ideas?
Darth Lars Master Member Jun 9, 2015 #2 Is the endcap also hollow? Then make a plug that attaches to both of them. Either cover up or cut off the threaded section.
Is the endcap also hollow? Then make a plug that attaches to both of them. Either cover up or cut off the threaded section.
thd9791 Master Member RPF PREMIUM MEMBER Jun 9, 2015 #3 Yes, hardware wise, you'll need some plug that runs through both of them. It will be better than gluing two hollow tubes together!
Yes, hardware wise, you'll need some plug that runs through both of them. It will be better than gluing two hollow tubes together!
