Beginner Really!!!!

Thread starter Neotron
Start date Apr 26, 2012

Scuba Bob

Active Member

May 2, 2012

As I said on my PM i wouldnt use the one on the left at all but the one on the right would work as a basic core for some sculpts. Bear in mind that this head (which looks like a hairdressing mannequin head) is going to be much smaller than the average head. For the time being a good set of calipers might be a good investment (under $20) to help you with scaling. When I'm sculpting a human head I will always break out the calipers and use my own head as a reference of where things should be and how wide things should be.

This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.