Batman v Superman - Mech Suit_Halloween Costume 2015

[Kaver84]

Thanks! I know its not movie accurate but I there aren't many files out there for this one yet and I didn't have time to model them myself.

- - - Updated - - -

Here are some pictures of the rest of the suit. Still waiting on the cape fabric. Should be in the mail today.....

 

[Kaver84]

Helmet progress. I 3D printed some magnetic holders for the back section and got the lighted eyes hooked up. I have some black accents for the chin piece drying in the garage, then its just the cape. The fabric didn't show up today so I'll have to find something local.

 

[BryanVera]

Helmet progress. I 3D printed some magnetic holders for the back section and got the lighted eyes hooked up. I have some black accents for the chin piece drying in the garage, then its just the cape. The fabric didn't show up today so I'll have to find something local.

View attachment 548318View attachment 548319View attachment 548320View attachment 548317

looks awesome! how exacly did you achive the eyes!?

 

[Kaver84]

I used electrolumenescent ribbon thats powered by a coin cell inverter. The inverter runs on a CR2032 so its super small and just barely fits on the back side of the helmet. I purchased the materials from Adafruit.com.

 

[BryanVera]

I used electrolumenescent ribbon thats powered by a coin cell inverter. The inverter runs on a CR2032 so its super small and just barely fits on the back side of the helmet. I purchased the materials from Adafruit.com.

Nice! Looks awesome

 

[Kaver84]

The suit was a success! Here are a couple of pics of the final product.

 

[BryanVera]

The suit was a success! Here are a couple of pics of the final product.

View attachment 548961View attachment 548960View attachment 548959

Looks pretty awesome! Can you see well? Also, I'm currently building the chest area from KadzaNeon's files too, and I have noticed that the forearm files don't have the spikes at the sides and yours do. Would you be willing to share your files? Let me know or pm me and awesome work man, hopefully my enn results look as simular as yours as possible!

 

[Kaver84]

A few more pics that aren't quite as blurry.

 

[Kaver84]

I 3D printed the vambraces on the forearm and connected them with screws through the foam forearm to the elbow hinge. Without a 3D printer and the elbow joint they wont do you much good. I can certainly supply them if you'd like though just in case you have access to a printer. Just shoot me a message if you still want them.

 

[SyntaxisDan]

Great build!

 

[prime3446]

Kaver84 where did you get the files for the belt ? trying to find it on this thread http://www.therpf.com/showthread.php?t=239462 but can't seem to find it, thanks !

 

[disasterology]

I used electrolumenescent ribbon thats powered by a coin cell inverter. The inverter runs on a CR2032 so its super small and just barely fits on the back side of the helmet. I purchased the materials from Adafruit.com.

Is that a blue LED?

 

[NewOrleans76]

Kaver84, GREAT SUIT. I am new to the world of pep building and have been searching for the B v S armor .pdo files. Are you willing to share your files with me? I would like to attempt my first build, using foam. Thanks