Thanks JKNO for the confirmation, I'll definitely make that modification to mine!
guabe - The bottom looks good! The inside is somewhat cylindrical, but more like a D shape, the flat side would be where the large hole in the front is. In other words the sides and back are thicker than the front (if the front wasn't removed), with the sides of the opening being somewhat straight back before curving in to the back. Like if you boolean-ed an extended cylinder with flattened side from the solid block, of if that makes sense. A bit hard to describe, and hard to photograph too because it's so black. And forget what I said about the edge chamfer, that actually looks pretty good. I hope that makes sense...
This is all minor of course, and would mostly be covered up by the wire greebly that goes in the opening.
guabe - The bottom looks good! The inside is somewhat cylindrical, but more like a D shape, the flat side would be where the large hole in the front is. In other words the sides and back are thicker than the front (if the front wasn't removed), with the sides of the opening being somewhat straight back before curving in to the back. Like if you boolean-ed an extended cylinder with flattened side from the solid block, of if that makes sense. A bit hard to describe, and hard to photograph too because it's so black. And forget what I said about the edge chamfer, that actually looks pretty good. I hope that makes sense...
This is all minor of course, and would mostly be covered up by the wire greebly that goes in the opening.
