Arc Reactor Size?

TheConanRider

New Member
I have printed a 3d model I found online and I was wondering if anyone could give me the rough size of the actual prop. The prop I downloaded has a face radius of 55mm which is fine (actually it is a little bit too small for my liking but I can live with that) and a depth of 110mm which just seems far too long. I'm not bothered about it being accurate it just needs to feel right in my hands.
medium_DSC_0778.JPG
*not my image but the image of the model uploader.

878870-vlcsnap_557974_large.png
*image from movie (from wiki)
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top