Arc Reactor Help


Sr Member
I am working on a custom build, but seem to have hit a snag. I have no clue how to get some decent looking 'brass rings' for the center section of the reactor.(see pic) I tried to cut them from styrene, but can't seem to get a good, smooth circle regardless of how hard I try. Any suggestion on what to use in its place? Thanks!
Thanks for the help guys, I decided to go with the PVC pipes, a simple and easy solution to the problem (and a DUH! moment for me). I think that the rings look really good, will post some progress soon.
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.