Another TDKR Batman EMP Gun

[TDKOGC]

Hey everyone,

Here we go then, I know there are a few about but I have been desperate to get one and need to get my printer doing something.

This has been a collaborative project, thanks to Andy W for accurate dimensions that he used on his awesome gun and 13doctorwho for a beautiful 3d model.
Andy W - If you need an EMP Gun, his looks great
13docotrwho - If you want a 3D Designer, first pic speaks for itself

Early days so far, I have the trigger printed up and the first part of the barrel is on the printer as I type.
The part still needs cleaning up and the grip is to be adjusted for a snug fit.

What do you think ?
Is it a :thumbsup, or :thumbsdown

 

[TDKOGC]

Next part done.

 

[TDKOGC]

I know it wasn't in the film for long, but I think it was still am impressive bit of kit.

Sticky Bomb Gun for me next I think.


A couple of more update shots, starting to look a little more familiar.

I still need to finish it up which will happen when it is all printed, a bit of sanding and filling should do the job.

 

[cadu1990]

The grip is printed?

 

[TDKOGC]

Hey cadu1990,

No, the grip was identified as a Magpul M4 grip, I found a nice replica on eBay that fit the bill.
I have a little adjusting to do, then it will fit nice and snug.

I thought about printing the grip, but I don't think the rough detail on the grip would come out right.

 

[TDKOGC]

Getting there ...

 

[TDKOGC]

Nearly there now.

 

[Havok613]

That's looking good!!!!

 

[TDKOGC]

Well, that's phase 1 done. The prototype is complete.

Now I can see what is right and what needs altering, before it then gets re-printed in High Res.