Anigrand Star Destroyer

Redfinger

Well-Known Member
I recently acquired one of these kits, not a recast, but from the original run. I have been doing quite a bit of searching over the past few days familiarizing myself with other builds. One part I am not overly happy with is the detail on the turbo lasers. I seem to recall the studio model had 8 cannons for each gun? Any suggestions on replacing those parts? I was thinking of some brass barrels from an appropriate sized battle ship kit, but I am not sure what scale I would need to look at, any suggestions?

I would also appreciate any sage advice from those who have ventured down this path before. This is my first kit of this size, though I did do an RC Radiant Cruiser, but I feel as if this model is much more complex. Additionally, I am lighting this beast so that adds another complicated layer.

Thanks in advance!

A.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top