Hello,
I apologize in advance if this has been covered, but, I eventually want to build an EMT/ERT Refit Enterprise.
My main concern is how to handle the surface details.
1) Better to sand off leaving the long pie cut lines from the bridge to the saucer edges(what about the lower hull & nacelles?)
2) Use pink car filler and fill everything in except for heaviest lines? Again See question re what to keep, fill in.
3) Build as is.
As much as I want a Polar Lights 1/350, it isn't in the budget.
I'm also having a lot of fun locating one in Ontario Canada. Found a few online, but got the "we dont ship to Canada" message.
Grumpy me says just get the 1/1000 kit. Sheesh.
Any other suggestions/tips?
Thanks for reading. Any advice greatly appreciated.
I apologize in advance if this has been covered, but, I eventually want to build an EMT/ERT Refit Enterprise.
My main concern is how to handle the surface details.
1) Better to sand off leaving the long pie cut lines from the bridge to the saucer edges(what about the lower hull & nacelles?)
2) Use pink car filler and fill everything in except for heaviest lines? Again See question re what to keep, fill in.
3) Build as is.
As much as I want a Polar Lights 1/350, it isn't in the budget.
I'm also having a lot of fun locating one in Ontario Canada. Found a few online, but got the "we dont ship to Canada" message.
Grumpy me says just get the 1/1000 kit. Sheesh.
Any other suggestions/tips?
Thanks for reading. Any advice greatly appreciated.