Service 3d printing

IM Nation

Sr Member
Hi GUYZ I'm now offering 3d printing service
my 3d printer is a Mankati full scale XT
build size of 250mm X 250mm X 300. Or 10x10x12 inches
my rate is 8$ per hour
pm me for more info






 
Checking in again to see if you're still offering your 3D print service and to see if you've had a chance to look at the file I sent. Thanks.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top