1/144th Prometheus scratch build
- Thread starter TheNylonGag
- Start date
Caretaker10
Active Member
Nice job as always Gag.
How's the wrist doing??? Can it keep up with you?
How's the wrist doing??? Can it keep up with you?
Aaaaaahhhhhhhhhhhh, I needed that update....
As always, beautiful work.
As always, beautiful work.
Nice job as always Gag.
How's the wrist doing??? Can it keep up with you?
Cheers mate
Wrist still sucks
But i manage
Gag
- - - Updated - - -
Evenin All
Cheers guys
Quick Teaser vid
Bad sound
Sorry
Gag out
Last edited by a moderator:
stigmorgan
Sr Member
This is so unbelievably cool and light-years beyond anything I could envision
Vacformedhero
Sr Member
Brilliant details , very approprate
PhortKnight
New Member
Your level of detail is astonishing!
Ello,
So whats been happening, not much to be honest, zero hours in June and only 11 in July.
Think my mojo was lost.
Think i got it back
Lets see.
Thanks for the positive vibes dudes
On with the show
So after the detail panels were finished i had to get all the inner walls to the same stage
This is the main back support
Cut the outer rings
Group picture
Then started work on the small additional detail panel that i realised i would need to fill a void
X4
dry fit
Ready for primer
made so really small ones again to fill gaps and add depth and interest
Then it was time to move on to the nozzel internals
Started with small vector actuators
This is the vector thrust bulkhead made from a mouthwash two pack carry handle, separated and cleaned up, drilled to receive the actuators
Added T and U channel
And thats about it so far
Did manage to finish my little shuttle launch side project
Thats it for now kids
Take care
Gag
So whats been happening, not much to be honest, zero hours in June and only 11 in July.
Think my mojo was lost.
Think i got it back
Lets see.
Thanks for the positive vibes dudes
On with the show
So after the detail panels were finished i had to get all the inner walls to the same stage
This is the main back support
Cut the outer rings
Group picture
Then started work on the small additional detail panel that i realised i would need to fill a void
X4
dry fit
Ready for primer
made so really small ones again to fill gaps and add depth and interest
Then it was time to move on to the nozzel internals
Started with small vector actuators
This is the vector thrust bulkhead made from a mouthwash two pack carry handle, separated and cleaned up, drilled to receive the actuators
Added T and U channel
And thats about it so far
Did manage to finish my little shuttle launch side project
Thats it for now kids
Take care
Gag
Vacformedhero
Sr Member
Very intelligent use of everyday items mixed with kit parts , a perfect demonstration of how to detail a model, cannot wait to see this in primer
Your post makes me happy -glad you got your Mojo back.
Always inspired every time I open this thread.
Similar threads
