Having Trouble with page size in pepakura.

Thread starter Skitterine
Start date Jul 31, 2018
Tags

pepakura designer

Skitterine

New Member

Jul 31, 2018

Hello! I hope this is the right place to post this.
I'm Having some trouble figuring out how to Scale projects in Pepakura To the paper size. It starts me out with a standard 8x11. but most of the pieces are in the 7inch and above range, making them tiny when printed. I've made the scale of the paper larger, however I dont know how to create more pages! Could someone give me some tips on how this works?
As a note, The whole projects size would fit me fine, no need for scaling, my only issue is paper size and placement.

Thanks!

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.