Sleepy hollow tree of death

number9

number9

Member
It's been awhile since my last post. I'm hoping I'm in the right thread. I need to recreate the twisted tree of death from sleepy hollow. 1/8 scale. I have poor to not so good clay skills. I'm also trying to keep the weight down as low as possible. Any suggestions or build ideas out there?

Thanks.
 
Air clay over a twisted aluminum wire (several gauges) armature sounds like what you want. At 1:8 scale, your lack of skills won't matter too much, and you may surprise yourself at how much fun it is and how well it turns out. Get good photo images and go to town. Have fun!


Sent from my iPhone using Tapatalk
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

helix_3
Hollow stucco castings for outdoor use?
Replies
7
Views
681
Gee2
Gee2
Antonis13
Questions about different type of plasters.
Replies
3
Views
453
udog
udog
Darth Infamous
The Balrog Of Moria
Replies
12
Views
1,256
Darth Infamous
Darth Infamous
Antonis13
HELP. I need suggestions of how to make an armature.
Replies
2
Views
536
Antonis13
Antonis13
speedtwin
Richard Edlund Pignose Knob (kind of of Star Wars related)
Replies
2
Views
778
joberg
joberg
Back
Top