Firefox3D
Well-Known Member
Got a bit ahead of myself, knew I had to fix a few little things that would be an issue at 1/48th and fix a few bugs (one really hard to find) to get the part watertight. Also had to add the stand fixing and internal supports so it hangs together while printing. I had to do this part in different software as it handles merging/intersecting STL's much better than Sketchup, and I had used it a small amount but realised I was still on that initial steep learning curve.
However the good news is I am essentially on holiday this week so once I get back from a small errand I can finish the supports and get it printing, it is going to take nearly a day to print, so really want to get it right first time!
However the good news is I am essentially on holiday this week so once I get back from a small errand I can finish the supports and get it printing, it is going to take nearly a day to print, so really want to get it right first time!