Tusken Raider face parts?

darthjones

darthjones

Sr Member
Hey, gang - where does everyone get their Tusken aluminum parts made? Just wondering if there is a machinist that everyone prefers.

Thanks!
 
I have a mini metal lathe so that is how I do mine. As far as the teeth I used a block of aluiminum carved with a dremel bit. It sounds like alot of work but it cut it like butter.
 
Hey darthjones
Do You have some Acurate ANH face part measurement that aren't the bantha rider specs? I see a lot of face parts out there that just don't look right...Would be nice to see some metal parts offered that are accurate(not giant eye stalks with large inner holes or small with small inner holes)and that have the right taper. Looks to me that the eye stalks on all the refence pics have a very pronounced taper or conical shape in the side view shots. I see more strait(tube like with not much taper) eye stalks being offered mostly.
 
Last edited:
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

P
Tusken Raider ANH Gaffi Complete Build
Replies
5
Views
351
Master Windu
Master Windu
RandomPropGeek
Tusken Raider ANH Complete Build
2
Replies
27
Views
2,682
RandomPropGeek
RandomPropGeek
J
Tusken raider helmet
Replies
0
Views
688
jeanluc83
J
P
Tusken raider Hero Gaffi (Gaderffii) build, need info.
Replies
3
Views
643
RandomPropGeek
RandomPropGeek
BonesAreDollars
Revised Tusken Raider helmet
Replies
4
Views
1,025
BonesAreDollars
BonesAreDollars
Back
Top