Hey!
Just starting out trying to get into the 3d modelling so I can justify a printer. Wondered if anyone knew any obvious tips when dealing with curves etc.
For instance. In the picture. You can tell theres some points where the Ironman curve is. Is there anyway to make it like some kind of average curve without deforming it out of shape? Same with the faceplate surface. I think its almost there. Looks smooth with the subdivision on. But my plotted vertex points are sort of eyeballed in from the side view due to the shape.
Any other obvious tips from you lot with experience that you ran into doing the same stuff is greatly welcome.
That's the thing with so many tutorials. Can take ages to find out whats wrong and its something so simple!
Actually modelling the mk vii but this is the best reference I can find with side views so making the mk iii then just going to edit the vent etc to a front view picture. (If that makes sense)
~[/URL
Just starting out trying to get into the 3d modelling so I can justify a printer. Wondered if anyone knew any obvious tips when dealing with curves etc.
For instance. In the picture. You can tell theres some points where the Ironman curve is. Is there anyway to make it like some kind of average curve without deforming it out of shape? Same with the faceplate surface. I think its almost there. Looks smooth with the subdivision on. But my plotted vertex points are sort of eyeballed in from the side view due to the shape.
Any other obvious tips from you lot with experience that you ran into doing the same stuff is greatly welcome.
That's the thing with so many tutorials. Can take ages to find out whats wrong and its something so simple!
Actually modelling the mk vii but this is the best reference I can find with side views so making the mk iii then just going to edit the vent etc to a front view picture. (If that makes sense)
~[/URL