weaselflinger
Sr Member
I've always wanted a 1:1 martian bust and started collecting reference photos to sculpt one from from scratch. On a whim, I thought I should check eBay just in case casts from the full sized production martians were floating around and I found this:
It is only the front half, but I got it for $40 and it matched the production made martians exactly (saving me a ton of time). The first step was to hollow out some of the foam from the back, mount it to a base and add expanding foam.
After trimming the foam back a little, I roughed in the back half with ceramic clay.
I'm about 5 hours in and have most of the left side knocked out.
It is only the front half, but I got it for $40 and it matched the production made martians exactly (saving me a ton of time). The first step was to hollow out some of the foam from the back, mount it to a base and add expanding foam.
After trimming the foam back a little, I roughed in the back half with ceramic clay.
I'm about 5 hours in and have most of the left side knocked out.
Last edited: