What's the best?

Your top 2 are Magic Sculpt and Aves.
Both can be smoothed with water as you're working with them.
Aves does have a "safety solvent" that is used on your tools and is good for softening the material and blending edges.

I had a 8oz (each tub) of Magic Sculpt that lasted me about 10 years, I have only recently started using Aves.

Both are used by figure producers.
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.