What Glue are you using for PLA 3D Models

B4DW0LF

Well-Known Member
I've been playing with a number of different glues but I'm not finding anything that I'm 100% happy with,

So what do you guys recommend?
 
I have seen people using left over/reclaimed PLA mixed with acetone to create a "glue" slurry that welds/bonds pieces. I seem to recall X-Robots also uses that method.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top