Done / Completed .: Vintage Found Part :..: ESB Luke Skywalker GRAFLEX Clamp Cards / PCB Boards :.

First 12 should go out TOMORROW!

Those of you who ordered one, I made these just a hair wider than 5/8" (and I mean just barely)... they fit my Roman's replica GRAFLEX, but are tight. A little time with some sandpaper should make them fit perfectly. I did this to account for any loose or sloppy GRAFLEX clamps out there.


esbclampcard5.jpg
 
Last edited:
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top