-
Welcome to the Project Runs Forum!
This forum is intended for interest gauging and active runs. Due to the transient nature of this forum, please keep all research and ongoing discussion in one of our main forums so your information is not lost.
Only Premium Members can start a new run.
Interest Tony Stark's F.R.I.D.A.Y. Chip - Age of Ultron
- Thread starter bobatrek
- Start date
Stormshadow
Well-Known Member
I own a few of the actual sony SxS cards.....if you offer a good quality sticker(s)(blue circuitry and the day of the week) , I would be down for a few as well..to apply to the actual cards....let me know 
I own a few of the actual sony SxS cards.....if you offer a good quality sticker(s)(blue circuitry and the day of the week) , I would be down for a few as well..to apply to the actual cards....let me know
I'll need to see how this plays out first.
Looking good so far!
I would maybe have gone for laser cut styrene sheet of varying thickness (0.5mm,1mm and possibly 2mm layered up) to build this little prop, would save you sanding,priming and then sanding back the print lines.
Just a thought, either way I'm sure the finished prop will be great.
I would maybe have gone for laser cut styrene sheet of varying thickness (0.5mm,1mm and possibly 2mm layered up) to build this little prop, would save you sanding,priming and then sanding back the print lines.
Just a thought, either way I'm sure the finished prop will be great.
dotails
Active Member
Last edited:
