Specs for the Bowcaster front piece? Measurements to machine it..

Thread starter Andymac84
Start date Dec 14, 2016

Andymac84

Sr Member

Dec 14, 2016

Hi. I have a cast of the Horton stock, and would have needed the specs (Length/width/thickness) of the Bowcaster front piece. Hopefully someone will share some raw specs. I would like to create this myself. One pic is from wuher da brewer, hope that's okay bro.
Need the measurements from the piece in the red shapes:

Many thanks for any help or wink..

This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.