Sealing foam latex?

Thread starter drftfan
Start date Sep 15, 2011

drftfan

Sr Member

RPF PREMIUM MEMBER

Sep 15, 2011

I am obtaining a prodution run piece from one of the batman movies. I am not sure if it is painted already or not. But how can I go about sealing it to protect the foam from any future damage?

This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.