Scratch built Barrel Vent for Pulse rifle

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


propmainiac

Sr Member
RPF PREMIUM MEMBER
Hello everyone and Happy New Year to all at the RPF!

I have a resolution for the new year and that is to finish my pulse rifle by march of this year.
Many things left to do on it. Right now Im Making the Barrel vent from scratch. I found measurements on the Aliens Legacy site. Im working on a ten hole vent. I first cut 16 gauge steel and bent it with a bending brake. Its supposed to be 40 mm wide I somehow made it 50mm wide. To reslove this I split it down the middle lengthwise. This removed about 1/8 of an inch and was now the correct width. I then cut the basic shape of the vent out then cut the area that has the vent slots out.
Im making this in two parts the pics will explain it better. Enjoy
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top