Roman Props V2 + Rudy Pando CC Install Help

[DrTautology]

Is there anyone here that has any experience with this install? I'm fairly new to the hobby and I'm looking to do a proffie+neopixel install on this hilt. If you could maybe share your wiring diagram from the proffie configurator, or provide information on what would be the best chassis and switches to go with, I would really appreciate the help. I do see that Goth3d offers a CHASSIS for the MK1 and pando CC, but I'm not sure if this same chassis will work with the V2. I found a video of a guy that has done this install so I know Goth did at least offer a chassis for this hilt at one time.

Regards,
D

 

[gjw]

Goth never made a chassis for this but the MK1 chassis can be used with minor modification.
Don't ask me what modification -- that's just what I was told when I was contemplating this same install.

 

[ObscureReferenc]

I just ordered this one -

Roman Props MK1 - Padawan Var 2 by Rick_D_Ryo on Shapeways

Check out Roman Props MK1 - Padawan Var 2 by Rick_D_Ryo on Shapeways and discover more 3D printed products in Maker/DIY.

www.shapeways.com

I have Rudy Pando v2 crystal chamber and am using the cfx chip. I know there is another version that's multiboard ready. I figured I would take a swing and see how it fits. I went cheap so it won't get here until the end of the month but will gladly let you know how it goes.

 

[ObscureReferenc]

So just arrived, and seems like it will work fine. Got to clean it up a bit, and going to be a tight fit for all the wires, but that's all part of the fun.