Pyramid Head Almost Finished

MagusDave

New Member
So I am building my very first replica from scratch using 1/4" and 1/2" foam boards, metal grating, PVC piping, and some fabric. I think for a first timer it came out pretty good. I've run into a problem: exposed foam edges. Any ideas on how to protect my edges? I thought about edging trim. Thanks in advanced.
PS: I didn't think this was the right place to show progress, if someone would point me in the right direction, I'll show each step in another thread.

IMG_3595.JPG
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top