Predator head conversion


New Member
I am in the process of converting this cardboard and epoxy Predator head build into a latex/silicone version...I want to try and make the jaw mandibles moveable via animatronics or a squeeze bulb method...Are there any resources for that type of thing?
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.