I am doing a small run of 10 sets of electronics for the Boomerang Phaser. The electronics are designed to specifically fit the Stapleton Productions body kit, Roddenberry kit, and a number of 3D printed kits. These electronics have full lights and sounds that replicate the screen used hero props; all of the lights run identically to the screen-used version and the sound is very authentic. There are 3 selectable firing modes: stun, heavy stun, and kill. Each mode has a separate firing sound; stun and heavy stun are pulsed shots, while the kill mode has a continuous firing sound. There is also a diagnostic mode and overload feature with explosion sound effect. There are two buttons to control the settings (UP & DOWN) and third button for the trigger. The two boards are fully assembled and are ready to install (no soldering required). The display is composed of 16 LEDs: LEDs 1-8 are green (Stun setting), 9-12 are yellow (Heavy stun), and 13-16 are red (Kill setting). You can also request me to assemble the circuit where all LEDs are green to make it screen accurate.
Here is what you will get with each kit:
If you would like to get in on this run and order a set of these electronics simply make your payment by clicking HERE.
Here is what you will get with each kit:
- 2 fully assembled circuit boards (main logic board with buttons and display board).
- LiPo battery (300 mAh) with charging port and charging cable
- 16-LED display; super bright firing LED; separate UP and DOWN beeps; 3 firing sounds; diagnostic sequencing mode; Overload mode with racing display and explosion sound; and automatic shut-off when phaser is inactive for more than 30 seconds.
- Wiring diagram and instruction sheet
If you would like to get in on this run and order a set of these electronics simply make your payment by clicking HERE.
Last edited:
