Pics of my prop room

That ArcSoft program is amazing! I just redid the panoramic photo with only a minimal amount of effort!

If you haven't seen the image since 11:30 EST, check it out again. Basically, it's the same except it's much cleaner. Only one part looks a little odd instead of 2 or 3.

Thanks for the tip!
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top