Trying to get back into the groove to finish the pulsars. Figured id try to do something with these molds i made of Rustys Deatomizer shells . I've had this "limited shelf life" High temp resin for Oh about 3 years now and figured id see if its still any good . Anyhoo, i've molded it up in sections so i can "adjust" it to my liking and make a new master. Ill post the process here. Im am lengthening the front end, reshape the grip, lowering it and re-adjust the angle. Lower, shorten and thicken the side pods. Shrink and lower the rear pod. Also going to replace the center body, It needs to be tad wider to properly fit the barrel or its going too be fragile. An issue i had with rustys. Basically redoing the whole thing...lol.
