Limited Run Luke's ANH Macrobinocular Machined Triangle Piece

OK people, I updated the list. I need some feedback on the open end. To my knowledge, there was never a picture of this on screen - If anyone has one, please post it up! This is so old I need to meet with the machinist again, so do we want a open end to add mesh or some detail or a solid piece? Or just a solid piece without any open end? Post up, thanks!

Chad
Tatooine Machine
 
Depends on what the consensus is for accuracy. I see mostly solid ends. Would also need the mesh if that was the route planned to go. Happy to see this as a possibility again.
 
Even without bill fimm, it looks from the list as if we have the necessary numbers.

I hope that means a green light on this run. :)

I like the mesh, but would certainly defer to evidence that it was solid.
 
I like the mesh look too - it dresses it up a bit and adds some texture. If no reference photos dispute that, I like the additional detail. I have an itchy finger on my PayPal so I am ready!!
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top