Luke Ranch Saber- small upper grip screws?

Discussion in 'Star Wars Costumes and Props' started by Westies14, Mar 6, 2006.

  1. Westies14

    Westies14 Master Member

    Trophy Points:
    2,580
    Does anyone know the size or head of those small upper screws on the grips? Also, did the textured tape cover the screw and slot in the clamp? Are there any other interesting differences on this saber?

    Thanks in advance for the info.

    -D
     
  2. Westies14

    Westies14 Master Member

    Trophy Points:
    2,580
    bump- I remember when people still loved these graflexes... :(
     
  3. kurtyboy

    kurtyboy Master Member RPF PREMIUM MEMBER

    Trophy Points:
    2,870
    I don't have calipers but using a rule as near as I can make out its 4/32" or about 3.5mm.

     
  4. Westies14

    Westies14 Master Member

    Trophy Points:
    2,580
    Thanks for the info. Are you measuring a replica, or scaling a photograph? Are they flat head, philips head, or hex heads?

    -D
     
  5. DL 44 Blaster

    DL 44 Blaster Sr Member

    Trophy Points:
    1,730
    James Kenobi 1138 used to sell complete hardware sets for the ESB conversion. I'd try him :)
     
  6. kurtyboy

    kurtyboy Master Member RPF PREMIUM MEMBER

    Trophy Points:
    2,870
    I measured the screws I got from James Kenobi 1138. They are flat pan head (slotted?)... not sure of the correct terminology.

     

Share This Page