Looking for Wall Mounting Ideas for Blasters. Please Post Yours.

Discussion in 'Replica Props' started by wuher da brewer, Jun 12, 2006.

  1. wuher da brewer

    wuher da brewer Sr Member RPF PREMIUM MEMBER

    Trophy Points:
    1,781
  2. vaderdarth

    vaderdarth Master Member

    Trophy Points:
    2,741
    If you mean a single blaster, I've been thinking about this:

    just make a simple wooden plaque.....paint it gloss black........take some thin wood pieces and form some cradles by sanding out rounded areas on one edge............put the blaster on the cradles and center it where you like it best...........then mark the spots on the plaque........dremel out holes for the ends of the cradles.............paint the cradles black and glue them in place. Then attach a couple picture frame hangers on the backs and hang it on the wall like your favorite portrait. Now, you may want it more secure so you might want to drill a couple holes on each side and counter sink some screws, then pop in a couple wooden hole plugs.........the same color as the rest. You could further take some of that sticky back felt and line the cradles to protect your "babies".

    Wood is a suprisingly forgiving material to use for stuff when you are painting it a solid color.........you could also stain it to make it fancier. And a metal ID plaque is easily attached to wood.

    I haven't done this personally, but it's gonna happen in a couple months. :)

    Dave
     
  3. wuher da brewer

    wuher da brewer Sr Member RPF PREMIUM MEMBER

    Trophy Points:
    1,781

Share This Page