Looking for Vader lightsaber clamp pin

Brothervader

Well-Known Member
I was wondering if anybody out there knew if it was possible to purchase this piece separately. I recently body Master replicas lightsaber hilt, but the clamp pin was missing.
JPEG_20200914_173305_9205390867065128676.jpg
 
There might be a few people of facebook who have one spare. There was a time that people were replacing their clamp with a black bolt.... I think to replicate the RO saber.
 
Someone asked about this on facebook, and if you're replicating the ESB/Jedi clamp I would just use a piece of steel or a nail and cut it shorter!
 
That is the route I'm trying to take. The trick is going to be finding a drill bit that is strong enough and small enough to drill through the end of the nail.
 
Two hardware stores later, no luck. The exact size is a 1" pin with 3/16" diameter. I found this unique pin in my junk drawer. I'm going to see what I can turn this into.
JPEG_20200916_170637_8376992842864306353.jpg
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top