Jedi Training Remote - My version

[TazMan2000]

This is from the Luke0312 kit I purchased in 2013. I hope I did it justice. Finally assembled and painted. In the kit there was a length of Scotchlite which was cut on a Cameo Silhouette. The simple base was designed by me in Tinkercad and 3D printed.

TazMan2000

 

[DiggsBarklightr]

Nice job, looks great!!

 

[Psab keel]

That looks phenomenal! Great job!

 

[anamorphicWayne]

Excellento Taz!! Well done.

 

[Trooper_trent]

Very nice!!

 

[TazMan2000]

Thanks. I appreciate the likes and comments.

I forgot to mention, that some of the resin pins over and under the shock emitters broke off due to my rough handling. I broke all of them off and elected to drill and pin with brass rod. Also, the round 'C' shaped plastic parts were curved by hand. No need to vacuform styrene to get the right curvature. The 'U' shaped anchor shackles seemed to be a bit too small and round. I 3D printed replacements from Thingiverse.

TazMan2000

 

[JediJohn182]

Looks great!

 

[Trooper_trent]

Almost all if not all of the posts are now broken off of the real prop so you’re good either way.