Ironman/Pepakura questions

vittoriovamp89

New Member
First post here, sorry for the NEWB question. I am using some Ironman Pepakura files to build a Mak 5 suit. I was wondering if there was a thread of the rendered or finished pieces by piece and not per full suit. I want to be able to compare my foam folds and bends to see if they are being completed the correct way. The pepakura files are always a wire mesh, or less than finished imaging. If any of that makes sense? Thank you.
 
Hi Vitto; welcome to the RPF :thumbsup
You should try searching the forum for threads by Syrus54,DLowrider and Ironmaided.If anyone can show you proper ways to build Iron Man mark V suits,it would be them.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top