Notech
Member
I've got all the components together finally to motorize my IM Nation Mark VII helmets faceplate but am in need of a wiring diagram so I can put it all together and have it programmed.
I am using the Hitec HS 125mg slim metal gear servo, an arduino magnetic hall effect sensor, a cheaper alternative to the Arduino ( Arduino Compatible Pro Micro ATmega32U4 5V 16MHz Compatible Board. ) yes from eBay and am unsure as to the size of power supply I should use.
Any help and time in educating me would be greatly appreciated, I am an electrician by trade so am somewhat capable but this is electronics hence a fair bit more advanced than my knowledge and best left to the ppl who's field this is and the ppl I work with are just as useless as me so no help there
I can post pics of the parts if necessary
Thankyou Ladies and Gents
Mark
I am using the Hitec HS 125mg slim metal gear servo, an arduino magnetic hall effect sensor, a cheaper alternative to the Arduino ( Arduino Compatible Pro Micro ATmega32U4 5V 16MHz Compatible Board. ) yes from eBay and am unsure as to the size of power supply I should use.
Any help and time in educating me would be greatly appreciated, I am an electrician by trade so am somewhat capable but this is electronics hence a fair bit more advanced than my knowledge and best left to the ppl who's field this is and the ppl I work with are just as useless as me so no help there
I can post pics of the parts if necessary
Thankyou Ladies and Gents
Mark
