Hyperdine Labs servo motor

Thread starter KrangPrime
Start date Jun 20, 2011

KrangPrime

Master Member

Jun 20, 2011

Hey all,

I got the Light kit for my trap figured out.. that's all but done. But I can't for the life of me figure out how the servo motor goes together, or how the doors are supposed to be attached to it... I can't find any pictures online to help either....

If anyone has the same setup, I'd be most grateful for any pictures of a completed servo unit. I'd also be interested in how you got your lights to stay in the top of the trap. The few things I tried didn't work..

thanks from a beginner!

This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.