Limited Run Han Solo ROTJ Blaster Active Project

[teecrooz]

I would like the radiused sides.

 

[NeoRutty]

Seconded!

I would like the radiused sides.

 

[count0break]

5-8$ is a small price to pay for an accurate part.

 

[dr_slurpee]

Isn't that a different blaster in those pics? The scope and flash hider are different at least, though perhaps the other details are the same.



And this is the one we are talking about?

 

[Luke0312]

I'd like the vintage with radius sides. It's clear in the photo, so there is conclusive evidence. While it is cost is higher, it is a negligible price increase considering the entire project.

Indifferent on material type for it, if I had to pick, I'd say cast metal as I think it would probably match the texture closest and would have good feel/weight.

 

[Shadowknight]

I also vote for the radiused sides.

 

[morgan63]

of visual after I noticed that the washers do not have the same diameter of 0.3 mm or 0.2 some things like his would make calculations

 

[Trillion]

I'm for the radius sides as well, it just makes sense to me. Besides, like some have pointed out the price is negligible and most I feel in the end will be happy to spend the extra few bucks it takes to make it as authentic as possible. You won't regret it!

 

[extreme_too2]

Machined radiused sides. For an extra five bucks? Totally.

How would it attach, though? Simple epoxy?

 

[QCWolf]

$5-8 is a small price to pay for accuracy. I say let's do the radiused sides.

 

[Jedifather]

Not really a fan of cast metal.

Machined aluminum with radiused sides.

 

[Poseidon11]

I don't mind spending a few extra dollars to get it right. Radii please.

 

[tonelar]

Radiused.

 

[masterjedi322]

Sorry I'm late to the party, but count me in. Email also sent.

Sean

 

[Boba Debt]

IF you post an opinion on the Square detail be sure to mention whether you want it cast or machined and the type of material: Resin / Aluminum / Castable Metal

 

[NeoRutty]

I've always been partial to aluminum... but I'm good castable metal as well. Resin... eh... not so much.

 

[morgan63]

pvc it possible?

 

[Don93]

Machined aluminum square detail with radius gets my vote.

 

[morgan63]

Plastic as the room of origin!!!!!

 

[Curmudgeon]

I also vote for the machined part with the radius. A couple extra dollars isn't much to get it right!