Brothervader
Well-Known Member
I recently purchased a graflex hilt. I believe it is from TGS. The pins are sticking out too far. Is there a solution to this?
Is that the black cylinder that the pins attached to? On my Parks blade, it is recessed further down then my other hilt.View attachment 1279356
Thanks! What are your suggestions for finding an accurate blade holder?
If I recall his are for his Gen 1 graflex. So no.One last question. I mostly just looking for opinions. Romans props has a graflex blade holder. Do you guys think that would be compatible with a hilt from the graflex shop?
Roman's Gen1 is different than any other maker's Gen1 -- the sync pin holes are closer to the front than is typical. There are other tells as well, and owning a couple of his I can tell the replica in your photos isn't from Roman.Actually, I may have the Gen 1 graflex. Is there any way I can know which version I have for sure?
I contacted TGS and they said it is one of there gen 1 hilts. They are also releasing a new blade holder at the end of April. Thanks for all your help!
I recommend the Solo's Hold 7/8" bladeholder.
That’s your blade holder.. you can purchase short pins from a few different vendors