Dr. Who walking stick...


Well-Known Member
I know this isn't exactly a prop but I wasn't sure where to put it. I have been working on this for over a week now and I still need to do a few finishing touches and a coat of polyurethane... but I was excited to see what everyone here thought... so without further ado...





The rassilon is hand inlaid pewter that was hand carved and enameled, the cane head is curly maple, and the shaft is oak with a hand carved spiral.

Let me know what you think :)
conceptually I thought of making it resemble a sonic... but decided not to just because I wasn't sure which one to use... I also thought of doing the shaft of the walking stick in the profile of a Tardis... but thought I may save that for a future stick.
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.