Custom Mr. Freeze suit build and completion. ~PIC HEAVY~

Slagmite

New Member
That is stellar work! Nice job. How did you get the hoses to light up like that? Very cool effect!
M



Sent from my iPhone using Tapatalk


The hose is the metal insulation from a length of scrap insulated wire and the lights are just LED rope that i wrapped around it. They are attached to a PVC canister on the back that I fill with hot water and dry Ice. The Fog goes through the hoses and out through the entire suit.

- - - Updated - - -

What was used for the fog machine?

Just had hoses put through the cap of a PVC canister I made. I fill the canister with some hot water and drop Dry Ice in it. It only lasts for about 1 minute before I have to replace the hot water and a little more dry ice. Its more so for competitions instead of a regular trick. Works great. The fog is heavy and its cold :)
 

Miker

Well-Known Member
The hose is the metal insulation from a length of scrap insulated wire and the lights are just LED rope that i wrapped around it. They are attached to a PVC canister on the back that I fill with hot water and dry Ice. The Fog goes through the hoses and out through the entire suit.

Oh wow...clever. From your glowing picture the tubes at first appeared transparent to me with glowing webbing...such a cool effect! Again, nice work and attention to details.
- Mike


Sent from my iPhone using Tapatalk
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top