Cleaning & trimming a mask

Voodoomagik

New Member
So I have searched the Lair for a good hour and a half and either I am not searching what I am looking for correctly or I am blind and just dont see it lol. Starting my first mask and was curious whats the best way to clean up the raw latex mask(the little nubs and flaps of latex around the seams,crown,dread holes etc) Sorry if it was right there in front of the whole time.
 
Thanks much for the links,I searched apparently I just wasn't searching correctly lol. Will give the Dremel a try,need to get my monies worth out of this thing lol.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top