Sorry for delay
Actually printing main part today to make sure everything fits, Been a long time and I have had a fair amount to do at work and home so pleased its coming along.
Yes shared stunt is what its for. Its been very frustrating getting printer dialed in, Simon my friend did some great upgrades and we/he is still trying to get it running smoothly the 1st print was a fail but will see what happens tonight.
It works, I will make afew small adjustments, the speaker is a little tight. but the grub screw holds it nicely and card and battery fit well with a good cavity for the sound and it can escape via the clamp and back slots
Battery and card fit nicely, will be a little cram-fu needed.
Speaker is a little tight so I will increase the cut out on the opposite slot to were it slides in. this will make it sit a little more central. You can also see the wire run on the top of the chassis in this pic.
You can see the wire run just above the Y in the picture, Its enough but for ease I will make it bigger as there is enough room.
Re: Canny's Thread - Spirit of Ob1- Luke V3 update
Looks like it will work
Just need to make some brackets for the inside, and darn I lost the little rubber button to put over the tac switch. will have to go to the shop tomorrow.
After a few washes the petrol colour is looking much better too.